Influence of Electrodeposition Method, Solvent and Nanoparticle Concentration on Polypyrrole Coatings for Corrosion Protection of Mild Steel

Document Type : Original Article

Authors

Department of Chemistry, Kerman Branch, Islamic Azad University, Kerman, Iran

Abstract

In this work, it was demonstrated that the anti-corrosion performance of the polypyrrole (PPy) coatings on mild steel can be affected by electrodeposition method, electrosynthesis solvent composition and ZnO nanoparticles concentration. Three different electrodeposition methods, namely, cyclic voltammetry, galvanostatic and potentiostatic techniques were empolyed. The anti-corrosion performance of the PPy coatings was investigated by electrochemical impedance spectroscopy. The PPy prepared by potentiostatic method exhibited the best performance against corrosion of mild steel in 3.5% NaCl solution. Then, different mixtures of H2O/ethanol were investigated as electrosynthesis solvents for the preparation of PPy coatings on mild steel via optimized electrodeposition mode (i.e. potentiostatic). Evaluation of the prepared coatings introduced the pure water as the optimum solvent for the PPy electrodeposition. Lastly, the investigation of different concentrations of ZnO nanoparticles proved that the PPy coating containing 0.025% ZnO nanoparticles was the best coating against the corrosion of mild steel in the NaCl solution.

Keywords


  1. M. Hosseini. L. Fotouhi. A. Ehsani, M. Naseri, Enhancement of corrosion resistance of polypyrrole using metal oxide nanoparticles: Potentiodynamic and electrochemical impedance spectroscopy study, J. Colloid Interface Sci., 505(2017), 213-219.
  2. Y. Lei. N. Sheng. A. Hyono. M. Ueda, T. Ohtsuka, Influence of pH on the synthesis and properties of polypyrrole on copper from phytic acid solution for corrosion protection, Prog. Org. Coat., 77(2014), 774-784.
  3. S. Lee, H. Lee, Electrodeposition of Conducting Polymers on Copper in Nonaqueous Media by Corrosion Inhibition, J. Electrochem. Sci. Technol., 3(2012), 85-89.
  4. V. Venugopal. V. Venkatesh. R. G. Northcutt. J. Maddox, V. B. Sundaresan, Nanoscale polypyrrole sensors for near-field electrochemical measurements, Sens. Actuators, B, 242(2017), 1193-1200.
  5. A. Bahloul. B. Nessark. E. Briot. H. Groult. A. Mauger. K. Zaghib, C. M. Julien, Polypyrrole-covered MnO2 as electrode material for supercapacitor, J. Power Sources, 240(2013), 267-272.
  6. D. P. Dubal. S. H. Lee. J. G. Kim. W. B. Kim, C. D. Lokhande, Porous polypyrrole clusters prepared by electropolymerization for a high performance supercapacitor, J. Mater. Chem., 22(2012), 3044-3052.
  7. J. S. Shayeh. S. O. R. Siadat. M. Sadeghnia. K. Niknam. M. Rezaei, N. Aghamohammadi, Advanced studies of coupled conductive polymer/metal oxide nano wire composite as an efficient supercapacitor by common and fast fourier electrochemical methods, J. Mol. Liq., 220(2016), 489-494.
  8. S. Sadki. P. Schottland. N. Brodie, G. Sabouraud, The mechanisms of pyrrole electropolymerization, Chem. Soc. Rev., 29(2000), 283-293.
  9. C. Shi, I. Zhitomirsky, Electrodeposition of 0composite polypyrrole–carbon nanotube films, Surf. Eng., 27(2011), 655-661.
  10. K. Qi. Y. Qiu. Z. Chen, X. Guo, Corrosion of conductive polypyrrole: Galvanic interactions between polypyrrole and metal substrates, Corros. Sci., 91(2015), 272-280.
  11. A. El Jaouhari. M. Laabd. E. A. Bazzaoui. A. Albourine. J. I. Martins. R. Wang. G. Nagy, M. Bazzaoui, Electrochemical and spectroscopical studies of polypyrrole synthesized on carbon steel from aqueous medium, Synth. Met., 209(2015), 11-18.
  12. H. Arabzadeh. M. Shahidi, M. M. Foroughi, Electrodeposited polypyrrole coatings on mild steel: Modeling the EIS data with a new equivalent circuit and the influence of scan rate and cycle number on the corrosion protection, J. Electroanal. Chem., 807(2017), 162-173.
  13. H. Arabzadeh. M. Shahidi Zandi, M. M. Foroughi, Interpretation of Electrochemical Noise Signals Arising from Symmetrical and Asymmetrical Electrodes Made of Polypyrrole Coated Mild Steel, Prog. Color Colorants Coat., 12(2019), 25-32.
  14. F. Wolfart. D. P. Dubal. M. Vidotti. R. Holze, P. Gómez-Romero, Electrochemical supercapacitive properties of polypyrrole thin films: influence of the electropolymerization methods, J. Solid State Electrochem., 20(2016), 901-910.
  15. N. Aravindan, M. V. Sangaranarayanan, Influence of solvent composition on the anti-corrosion performance of copper–polypyrrole (Cu–PPy) coated 304 stainless steel, Prog. Org. Coat., 95(2016), 38-45.
  16. R. L. Zhu. G. X. Li. J. H. Zheng. J. W. Jiang, H. B. Zeng, Influence of electrosynthesis potential on corrosion performance of polypyrrole coated stainless steel and its mechanism research, Surf. Eng., 25(2009), 156-162.
  17. G. S. Sajadi. S. M. A. Hosseini. M. J. Bahrami, M. Shahidi, Electrochemical evaluation of polyvinyl butyral coating containing polypyrrole/ZnO nanocomposite for corrosion protection of Al Alloy, Prog. Color Colorants Coat., 10(2017), 205-216.
  18. A. M. Kumar, N. Rajendran, Electrochemical aspects and in vitro biocompatibility of polypyrrole/TiO2 ceramic nanocomposite coatings on 316L SS for orthopedic implants, Ceram. Int., 39(2013), 5639-5650.
  19. A. B. Moghaddam. T. Nazari. J. Badraghi, M. Kazemzad, Synthesis of ZnO nanoparticles and electrodeposition of polypyrrole/ZnO nanocomposite film, Int. J. Electrochem. Sci., 4(2009), 247-257.
  20. S. Sadki. P. Schottland. N. Brodie, G. Sabouraud, The mechanisms of pyrrole electropolymerization, Chem. Soc. Rev., 29(2000), 283-293.
  21. Y. H. Kim. Y. S. Kwon. M. Y. Shon, M. J. Moon, Corrosion protection performance of PVDF/PMMA-blended coatings by electrochemical impedance method, J. Electrochem. Sci. Technol., 9(2018), 1-8.
  22. M. C. S. S. Macedo. I. C. P. Margarit-Mattos. F. L. Fragata. J. B. Jorcin. N. Pébère, O. R. Mattos, Contribution to a better understanding of different behaviour patterns observed with organic coatings evaluated by electrochemical impedance spectroscopy, Corros. Sci., 51(2009), 1322-1327.
  23. M. Sababi. J. Pan. P. E. Augustsson. P. E. Sundell, P. M. Claesson, Influence of polyaniline and ceria nanoparticle additives on corrosion protection of a UV-cure coating on carbon steel, Corros. Sci., 84(2014), 189-197.
  24. F. Mansfeld, Use of electrochemical impedance spectroscopy for the study of corrosion protection by polymer coatings, J. Appl. Electrochem., 25(1995), 187-202.
  25. J. M. Sanchez-Amaya. R. M. Osuna. M. Bethencourt, F. J. Botana, Monitoring the degradation of a high solids epoxy coating by means of EIS and EN, Prog. Org. Coat., 60(2007), 248-254.
  26. D. E. Tallman. K. L. Levine. C. Siripirom. V. G. Gelling. G. P. Bierwagen, S. G. Croll, Nanocomposite of polypyrrole and alumina nanoparticles as a coating filler for the corrosion protection of aluminium alloy 2024-T3, Appl. Surf. Sci., 254(2008), 5452-5459.