Institute for Color Science and Technology (ICST)
Progress in Color, Colorants and Coatings
2008-2134
2383-1790
2
2
2009
08
01
Coating of Titania Nanoparticles on Stainless Steel Using an Alkoxide Precursor
71
78
EN
N.
Barati
Department of Materials Science and Engineering, Sharif University of Technology, Azadi Street, P.O. Box: 11365-9466, Tehran, Iran
M. A.
Faghihi Sani
Department of Materials Science and Engineering, Sharif University of Technology, Azadi Street, P.O. Box: 11365-9466, Tehran, Iran
10.30509/pccc.2009.78150
<em>Uniform nanostructure coating of TiO<sub>2</sub> was prepared on 316L stainless steel by sol-gel method using Tetra-n-Butyle Titanat (TBT) as alkoxide material. 316L specimens were coated with the mentioned sol by dip coating method. The influences of preparation condition, pH of sol on TiO<sub>2</sub> nanostructure coating were investigated. Their structural properties were examined at various calcination temperatures. The effect of drying cycle and solvent bath on crack reduction and the influence of withdrawal speed on thickness of the film was evaluated. Choosing of alcohol as a drying atmosphere could hinder the cracks formation. 400°C was desirable temperature to obtain nanoparticles from anatase phase. At this temperature it was found that TiO<sub>2</sub> films exhibited a uniform anatase structure with particle size of about 15 nm</em>. <em><br /></em>
Anatase,Nanostructure coating,Sol-Gel
https://pccc.icrc.ac.ir/article_78150.html
https://pccc.icrc.ac.ir/article_78150_b62fdaa407f604472cee95bd6caefd6a.pdf
Institute for Color Science and Technology (ICST)
Progress in Color, Colorants and Coatings
2008-2134
2383-1790
2
2
2009
08
01
Determination of Effects of Primer Surfacer Properties on the Automotive Coating Appearances by DOE
79
86
EN
S.
Bastani
Surface Coating and Corrosion Department, Institute for Color Science and Technology
bastani@icrc.ac.ir
A. R.
Massoumi
Paintshop, IranKhodro Co.
massoumi@yahoo.com
P.
Qodsi
Department of Polymer Engineering and Color Technology, Amirkabir University of Technology
qodsi@yahoo.com
A.
Karbasi
Department of Polymer Engineering and Color Techno, Amirkabir University of Technology
karbasi@yahoo.com
10.30509/pccc.2009.75757
In general, the evaluation of automotive coatings appearances favors (is considered preferentially) more than chemical and physical properties. Therefore, its improvement is most required. Studying appearance by means of QMS-BP technique, in which it measures some of the most important coating appearance factors, such as: the specular gloss, distinctness of image (DOI) and orange peel. In this article the influence of variation in the primer properties, such as thickness, roughness and gloss on the appearance of final coating system for two different primer types was studied. Results showed that increase in specular gloss would cause the intensification of NAP (Niveau d’Aspect Peinture) values, while increase in thickness and roughness would decrease it. Prog. Color Colorants Coat. 2(2009), 79-86. © Institute for Color Science and Technology.
https://pccc.icrc.ac.ir/article_75757.html
https://pccc.icrc.ac.ir/article_75757_1f6eee4251d6266b6a5057ccb2873e89.pdf
Institute for Color Science and Technology (ICST)
Progress in Color, Colorants and Coatings
2008-2134
2383-1790
2
2
2009
08
01
Achillea Millefolium, a New Source of Natural Dye for Wool Dyeing
87
93
EN
A.
Kiumarsi
Department of Organic Colorants, Institute for Color Science and Technology
akiumarsi@icrc.ac.ir
R.
Abomahboub
Department of Textile, Islamic Azad University
abomahboub@yahoo.com
S.M.
Rashedi
Department of Textiles, Islamic Azad University
rashedi@yahoo.com
M.
Parvinzadeh
Department of Textile, Islamic Azad University, Shahr-e-Ray Branch
mparvinzadeh@gmail.com
10.30509/pccc.2009.75758
Today, natural colorants are emerging globally due to the fact that they are safer and more environmentally-friendly. Natural dyes have been employed in dyeing Persian carpet piles for many years. In this study, the dried Achillea was used for dyeing wool yarns. The Iranian wool yarn was scoured, mordanted using Cu, Sn, Al salts and then dyed with different amounts of dried Achillea powder. Taguchi statistical method was employed to find the effective factors and results of the planned experiments, in order to optimize the dyeing factors. A L9 orthogonal array (four factors in three levels) was employed to evaluate the effects of different parameters in dyeing process. The colorimetric properties of the dyed yarns were evaluated in CIELAB system. Achillea found to have good agronomic potential as a natural dye in Iran. Dyeing with Achillea in conjunction with metal mordants showed enhancement in its fastness properties. Therefore it shows commercial capability for dyeing of wool yarns used as Persian carpet piles.
Natural Dye,Wool dyeing,Mordant,Achillea millefolium,Taguchi
https://pccc.icrc.ac.ir/article_75758.html
https://pccc.icrc.ac.ir/article_75758_e2f8424c70ce9c6cfbde485b4c74ed03.pdf
Institute for Color Science and Technology (ICST)
Progress in Color, Colorants and Coatings
2008-2134
2383-1790
2
2
2009
08
01
A New Method for Color Gamut Mapping by Genetic Algorithm
95
101
EN
S.
Gorji Kandi
Polymer Engineering and Color Technology Departmen, Amirkabir University of Technology
s.gorji@aut.ac.ir
M.
Amani Tehran
Department of Materials Science and Engineering , Sharif University of Technology
amani@aut.ac.ir
10.30509/pccc.2009.75759
To reproduce an image, it is necessary to map out of gamut colors of the image to destination gamut. It is clear that the best color gamut mapping introduces the perceptually closest image to the original one. In this study, a new color gamut mapping is purposed by the aid of Genetic Algorithm (GA). The color difference between the original and mapped images based on S-LAB formula was chosen as fitness function. The proposed algorithm was applied in CIELAB color space and special genetic operators were developed to meet the aim of gamut mapping. To increase the rate of convergence and have a faster algorithm, one of the initial population chromosomes can be obtained from the result of clipping method. The results showed that the new method introduces smaller color difference between the reproduced and original images in comparison with the common clipping method. The other advantage of the genetic color gamut mapping is that any new criterion for color image difference can be easily used as a fitness function. In addition, by this method the final colors are not restricted to the gamut surface and they may be included into the gamut
Color gamut mapping,Genetic Algorithm,Image difference
https://pccc.icrc.ac.ir/article_75759.html
https://pccc.icrc.ac.ir/article_75759_1160a94a5aea8bfa4a8940c4a576ca7a.pdf
Institute for Color Science and Technology (ICST)
Progress in Color, Colorants and Coatings
2008-2134
2383-1790
2
2
2009
08
01
Ultrasonic Assisted Extraction of Natural Pigments from Rhizomes of Curcuma Longa L.
103
113
EN
Sh.
Rouhani
0000-0002-1193-4314
Center of Excellence for Color Science and Technology,Department of Organic Colorants, Institute of Color Science and Technology
rouhani@icrc.ac.ir
N.
Alizadeh
Department of Chemistry, Tarbiat Modares University
alizadeh@yahoo.com
S.
Salimi
Department of Organic Colorants, Institute for Color Science and Technology
salimi@yahoo.com
T.
Haji-Ghasemi
Department of Organic Colorants, Institute for Color Science and Technology
haji-ghasemi@yahoo.com
10.30509/pccc.2009.75754
Ultrasound-assisted extraction (UAE) was evaluated as a simpler and more effective alternative to conventional extraction methods for the isolation of curcuminoids from turmeric plant rhizomes. The turmeric samples were extracted under indirect sonication in an ultrasonic bath, and compared with the conventional methods. It was found that the yield of ultrasound-assisted extraction was approximately three times higher than the traditional method. Taguchi experimental design was employed to study the effect of pH, solvent composition and extraction time on the yield of extracted curcuminoids from turmeric. The optimum combination was determined as a solvent composition ethanol/water 70:30 (V: V), pH of 3 and an ultrasound-assisted extraction time of 15 min. The extracts were analyzed using high performance liquid chromatography (HPLC).
Sonication,Extraction,natural pigments,Taguchi,Curcuminoids
https://pccc.icrc.ac.ir/article_75754.html
https://pccc.icrc.ac.ir/article_75754_e6d58952f743d251b5d4052f6d42d95e.pdf
Institute for Color Science and Technology (ICST)
Progress in Color, Colorants and Coatings
2008-2134
2383-1790
2
2
2009
08
01
Acetylacetonate Complexes as New Corrosion Inhibitors in Phosphoric Acid Media: Inhibition and Synergism Study
115
122
EN
A.
Ghanbari
Polymer Engineering and Color Technology Department, Amirkabir University of Technology
alirezaghanbari@aut.ac.ir
M. M.
Attar
Department of Polymer Engineering and Color Technology , Amirkabir University of Technology
attar@aut.ac.ir
M.
Mahdavian
Department of Surface Coating and Corrosion, Institute for Color Science and Technology
mahdavian-m@icrc.ac.ir
10.30509/pccc.2009.75755
The corrosion inhibition performance of acetylacetonate complexes of zinc(II), manganese(II), cobalt(II) and copper(II) on the mild steel substrate in 1M H3PO4 was studied using DC polarization. It was seen that the mentioned complexes decreased corrosion rate of mild steel in phosphoric acid media due to the adsorption on metal surface. The potential of mild steel shifted toward more active potentials. The cathodic Tafel slopes increased showing that acetylacetonate complexes are cathodic inhibitors. Presence of chloride ions in the electrolyte enhanced inhibition performance of acetylacetonate complexes due to synergism. Chloride ions provided by HCl had a better performance compared to NaCl.
Acetylacetonate complexes,DC polarization,Inhibitor,Synergism effect
https://pccc.icrc.ac.ir/article_75755.html
https://pccc.icrc.ac.ir/article_75755_900180abc9ef979e3d1c7b646737a303.pdf
Institute for Color Science and Technology (ICST)
Progress in Color, Colorants and Coatings
2008-2134
2383-1790
2
2
2009
08
01
Improved Fastness Properties of some Novel Triarylmethane Dyes on Acrylic Fibres
123
130
EN
N.
Saadatjou
Department of Applied Chemistry, Semnan University
saadatjou@yahoo.com
A.
Asghari
Department of Applied Chemistry, Semnan University
asghari@yahoo.com
10.30509/pccc.2009.75756
In this research, several series of triarylmethane dyes containing one or more terminal methoxy substituents with a variable tertiary amino groups have been used. These dyes have been applied to different substrates by using various methods including transfer printing and then their fastness properties were measured. These dyes shows exceptionally high light fastness (6-7) on acid modified polyacrylonitrile fibres.
Triphenylmethane dyes,Acrylic fibres,Fastness properties,Dye application
https://pccc.icrc.ac.ir/article_75756.html
https://pccc.icrc.ac.ir/article_75756_0c879c1c6343d44f4d4f91cab499bbcd.pdf